How To Format Pen Drive Or USB Flash Drive Using Command (cmd) Line

Format Your Pen Drive or USB Flash Drive Using Command Line (cmd) line

Pen Drive Or USB Flash Drive Format Using Command Line

Format All of us are familiar with this issue.Sometimes it is necessary to have a pen drive or USB flash drive format for viruses or various reasons.Pen Drive or USB flash drive Format is offered in different ways.If your pen drive is bootable.In that case, you will need to format your pen drive using the command line.If you give your pen drive format without using the command line, your pen drive will not be formatted.Some of the files go from pen drive which can not be fully formatted and can not be completely free. This will give you a pen drive format using the command line.Today I show you how to format USB flash drive or pen drive using command line promote (cmd).






To give a pen drive format using the command line, you first have to open the command line.Then connect you pen drive or USB flash drive with computer.Then type your command line "diskpart" , then press you computer keyboard enter button.


Now type this section of you command line " DISKPART>list disk " , then press on your computer keyboard enter button.When you click enter button , then you will see your Pen drive or USB flash drive or Hard disk.That means you can see 2 partitions.Disk 1 partition is your pen drive and Disk 0 partition is your Laptop or PC Hard drive.


Now write you command line " DISKPART>select disk 1 " , then press your computer keyboard enter button.When you press on the select button , then your pen drive will be selected.




Now write you command line " DISKPART>clean  " , then press on the keyboard enter button.When you press enter button , then you pen drive or USB  flash drive will be cleaning.




Then write you command line " DISKPART>create partition primary " , then press your keyboard enter button.When you press enter button , then your partition will be created.Please see the image below.


Now write you command line " DISKPART>select partition 1 " and press your computer keyboard enter button.When you can press enter button , then your partition 1 will be selected.


Now write your command line " DISKPART>active ", then press enter button. When you click on the enter button, then your pen drive will be activated.

Now write your command line " DISKPART>format fs = fat32 quick " , then press enter button of you computer keyboard.Please follow the image below.


Now type you command line " DISKPART>assign " and press enter button of your computer keyboard.Then check your pen drive or USB drive it's completely formatted or not formatted.I hope it's successfully formatted.


In this way you can easily format your pen drive.I hope everyone understand.If you face any problem and you have any question , so comment please.Thank you so much for visiting my website.Thanks a lot.